Installing the Artiteq Contour Rail is relatively simple and requires a few tools and a little preparation. Here are the detailed steps for successful installation:

Materials needed:

• Artiteq Rail Contour
• Fixing clips (supplied with the rail)
• Drill and suitable bits
• Screwdriver
• Screws and wall plugs (provided or suitable for your wall)
• Spirit level
• Marking pencil

Installation steps:

1. Prepare the wall

• Choose the location where you want to install the picture rail.
• Clean the surface so that it is clean and dry.

2. Mark the fixing points

• Place a fixing clip approximately 10 cm from each end of the rail. Add additional clips approximately every 40 cm.
• Use a spirit level to mark a straight line on the wall with a pencil.
• Mark the drilling points for the clips on the drawn line.

3. Drill and fix the clips

• Drill the holes at the marked locations.
  • Wall type : Adapt the drill bit and anchors depending on whether the wall is plaster, concrete, brick or wood.
• Insert dowels into holes if necessary.
• Secure the clips with screws, making sure they are properly aligned.

4. Install the rail

• Place the rail on the fixing clips.
• Press firmly to snap the rail into place. You will hear a "click" when the rail is securely attached.

5. Check the installation

• Make sure the rail is secure and straight.
• Test with a hanging wire and hook to verify that everything is in order.

Additional tips:

• If you are installing multiple rails, be sure to align them properly for a clean and aesthetic finish.
• Allow sufficient clearance from the ceiling to facilitate installation.
• If necessary, cut the rail to the correct length with a hacksaw.

Once installed, your Contour Rail system is ready to accommodate artwork or objects in an elegant and flexible way! ?